The stripes differ slightly in width and spacing. and
the outermost stripes run some 9 mm from the edge of the fender. Looking
closely at the alignments of the centering of corners, alignment of ends
etc, makes it clear that this is manual decoration work on an industrial
product, not very consistent, buy not at all bad viewed without a vernier
caliper in hand
On each side of the front fender there are three layouts of double
pinstriping and the stripes
The alignment of the ends is not perfect at the rear end either and it
is even more clear here.
There are variations both to the width
of the stripes, the distance between the twin stripes and the distance from
the outermost stripes to the edge of the panels.
Stripes
measured dimensions
variations
suggested means
a single pinstripe
1.7mm - 2.4mm
0.7mm
2mm or 5/64"
twin pinstripes
on front fender
distances in between
variates between
2.5mm and 3.4mm
1 mm
2,8mm or maybe 7/64" ?
Please support us with a
paypal donation
if you want the site to continue!
